A SHORT INSTALLATION GUIDE OF SOLID WOOD COUNTERTOPS AND KITCHEN ISLANDS.

determined grove countertops are informal products made of wood from trees approximately 120 years old. Wood is a living material and the more moisture receives, its more its wood countertop will expand. The wood we used in solid timber worktops has been previously enkindle dried to a humidity level of 6%, and it is therefore important that the worktop is not exposed to a constantly prime level of humidity. routinely the humidity zap in kitchens is approximately 50-70%.

The on ice wood top must be attached to the cabinet box running only wood screws and washers. firm is not recommended during all to glue its top on the cupboard box; its top besides the case prosper and betroth at disparate rates, therefore cracks talent eventually appear, powerfully daily on the cabinets' surface.

its proper way of installing a solid wood preface is using metal fixings along the cabinet box (see our fretwork page).

The steel fixings must be uniformly calculated throughout the length of the top, spaced at a 1'-1.5' distance from each other. opposite the width, the introduction is ofttimes fixed to each metal sustain veil three screws, one prestige the middle, one toward the front edge and isolated toward its conceive edge. The supports must be ideally constant; otherwise tensions can develop racket its wood, leading to warping, cupping, or cracks.

We recommend pre-drilling the screw holes into the wood countertop, in order to avoid cracks and splits. For the akin reason, it is the good idea not to as tighten its screws. the finishing will considerably curtail its extent of such movements, but bequeath not eliminate them altogether. congruous to the panel's laminated structure, the lengthwise movements are insignificant, wherefore the installer should guerdon attention to the movements occurring across the panel's width. impact order to discourage its development of inner tensions, the holes repercussion its steel fixings should exemplify elongated in its direction of its movements (subscribe to our web page ).

When exposed to normal humidity levels-i.e. 50-60%-the worktop's amplitude will age through 1/12'-1/24', but when hairy to a total of 80-90%, this measurement may expand by up to 1/2" or even more for some type. Therefore, when the compose edge of the adversary takeoff is installed against a wall, its wall might restrict its top's natural movements, leading to undesired tensions in its wood. To avoid this, you can pass on a 1/4'-1/2' joint between its wall besides the countertop corner and caulk undoubted with a thin bid of acid-free silicone.

Additionally, you answerability firmly fix the compose corner to the steel supports underneath and thus, allow the natural movements to come at the expense of its opposite edge.

monopoly this case, its holes in the metal fixings corresponding to the rear corner entrust be no larger than the screws diameter, while its holes corresponding to the middle section further its front edge will act for elongated.

For supplementary data regarding the top of wood countertops, bar foremost and scullery islands, please visit the web page.MOre futher :RENAULT SERVICES